The CRP MINI allows smaller industry compressors the ability to easily maintain EPA compliance. Like the other units in the IDC series; MINI units have an improved alumina silicate substrate media bed that prolongs the life of the unit and an internal decompression chamber. All you have to do is prime the unit and run your condensate lines to the unit with no need to purchase or install a separate decompression chamber.

As with all Clean Resources products the CRP MINI is designed to handle all compressor lubricants without regard to specific gravity, emulsification, or relative humidity. The CRP MINI is GUARANTEED to clean compressor condensate to less than 10ppm for the life of the unit or we will provide a refund through your distributor.

CRP MINI units provide an easy, convenient and cost effective method to keep your compressor room EPA compliant. The CRP MINI requires no electricity, is maintenance free, requires no pump and is not susceptible to mold growth. All CRP MINI units can be disposed of as non-hazardous special waste provided the liquid has been drained. Should your landfill not accept the spent unit, it can be returned to one of our sites. Simply fill out the disposal form at www.recycleoilsep.com and follow the instructions.

Our 100% Guarantee

The MINI has been designed using an improved alumina silicate substrate media that prolongs the life of the unit. It also comes with a durable, onboard decompression chamber. These new units come complete with an inlet hub, inlet caps, and an outlet hose. Prime the unit and simply run your condensate lines to the unit. With the MINI there is no need for a separate decompression chamber.

How It Works

Laboratory tested and proven in the field, the MINI is engineered to provide EPA compliant results. It is changing the world of compressor condensate management. Once the condensate from the waste stream is piped into the unit through the inlet hub, it comes into contact with our improved alumina silicate substrate media. These beds absorb the lubricant while repelling the water. The lubricant bonds with the media making the cleaned water easily disposable.

Works with these Lubricants

Diester-based lubricants, PAO-based lubricants, Glycol-based lubricants, Hydraulic lubricants, Food grade lubricant, Mineral-based lubricants
Androl, Ultra Chem, Summit, Royal Purple, All Gardner Denver Lubricants, All Kaeser Lubricants, All Quincy Lubricants, All Atlas Copco Lubricants, All Palatek Lubricants, All Compair Lubricants, All Ingersoll-Rand Lubricants,
All Sullair Lubricants except 24 KT*
*XKT Paks are available for silicone-based lubricants such as Sullair 24 KT fluid

MINI Instructions

Step 1

Position MINI unit on the side with the vent up.

Step 2

PRIME the MINI unit by pouring about 5 gallons of clean water through the vent. NOTE: Not priming the unit will cause premature failure.

Step 3

Position MINI unit upright and make sure water is flowing through the outlet hose.

Step 4

Install condensate line to the inlet hub.

Step 5

Do not allow air locks, kinks, or excess coil in drain hose.

Step 6

Confirm discharge flows freely.

Additional Details

Monitor water being discharged from unit. When water turns cloudy or maximum lifespan is reached, replace unit! Installation kits are available from Clean Resources.

Installation Video

If you have any questions contact your distributor or Clean Resources at 800-566-0402.

Save Parts Kit for Recycling. To start recycle process go to www.recycleoilsep.com

Installation kits are available from Clean Resources.

Additional Materials

Brochure

Download

Sizing

Download

Life Span Chart

Download